BWF BAM(BFM)高压并联电容器 　　用途  　　 本产品适用于并联在工频交流（50Hz或60Hz）电力系统中，用业提高功率因数，改善电压质量，降低线路损耗。  　　主要技术性能  1. 允许在1.1倍额定电压下长期运地，并可以在1.15倍额定电压下每24h中运行超过30min。2. 允冼在，由于过电压和高次谐波造成的有效值为额定电流的1.30倍的稳态过电流下运行。对于电容具有最大正偏差的电容器，稳态过电流允许达到额定电流的1.43倍。3. 电容偏差为：-5%～+10%。4. 损耗角正切值（在额定电压下，20℃时）a. 采用膜纸复合介质的产品不大于0.0012。b. 采用全膜介质的产品不大于0.0005（不含内熔丝）。带内熔丝的电容器损耗角正切值、在定货时协商确定。5. 电容器分户内型和户外型，并有适合于湿热地区高原地区及污秽等各种特殊环境用的产品。6. 产品符合GB3983.1-89《低电压并联电容器》和GB3983.2-89《高电压并联电容器》标准及IEC871-1(1987)要求。产品code产品型号Rated voltage(kv)额定电压Rated voltage额定容量Rated capacity (Kvar)额定电容Rated capacity相数Number of phases1BAM0.75-18-1W0.7518101.91(3)2BAM0.75-20-1W0.7520113.21(3)3BAM0.75-25-1W0.7525141.51(3)4BAM0.75-30-1W0.7530169.81(3)5BAM1.05-30-1W1.053086.61(3)6BAM1.05-50-1W1.0550144.11(3)7BAM1.05-60-1W1.0560173.21(3)8BAM1.05-100-1W1.05100288.71(3)9BAM3.15-200-1W3.1510032.11(3)10BAM3.15-200-1W3.1520064.21(3)11BAM6.3-12-1W6.3120.951(3)12BAM6.3-14-1W6.3141.11(3)13BAM6.3-16-1W6.3161.21(3)14BAM6.3-1-1W6.3181.41(3)15BAM6.3-30-1W6.3302.41(3)16BAM6.3-40-1W6.3403.21(3)17BAM6.3-50-1W6.3504.01(3)18BAM6.3-80-1W6.3806.41(3)19BAM6.3-100-1W6.31008.01(3)20BAM6.3-150-1W6.315012.01(3)21BAM10.5-50-1W10.5501.41(3)22BAM10.5-80-1W10.5802.31(3)23BAM10.5-100-1W10.51002.91(3)24BAM10.5-150-1W10.51504.31(3)25BAM10.5-200-1W10.52005.81(3)26BAM10.5-337-1W10.53349.61(3)27BFM11/3-14-1W11/3120.951(3)28BFM11/3-14-1W11/3141.11(3)29BFM11/3-16-W11/3161.31(3)30BFM11/3-18-1W11/3181.41(3)31BFM11/3-30-1W11/3302.41(3)32BFM11/3-40-1W11/3403.21(3)33BFM11/3-50-1W11/3503.951(3)34BFM11/3-80-1W11/3806.31(3)35BFM11/3-100-1W11/31007.91(3)36BFM11/3-150-1W11/315011.81(3)37BFM11/3-200-1W11/320015.31(3)38BFM11/3-334-1W11/333426.41(3)39BFM11-16-1W11160.421(3)40BFM11-18-1W11180.471(3)41BFM11-30-1W11300.791(3)42BFM11-40-1W11401.11(3)43BFM11-50-1W11501.31(3)44BFM11-100-1W111002.61(3)45BFM11-200-1W112005.31(3)46BFM11-334-1W113348.81(3)47BFM12-30-1W12300.661(3)48BFM12-40-1W12400.881(3)49BFM12-50-1W12501.11(3)50BFM12-80-1W12801.81(3)51BFM12-100-1W121002.21(3)52BFM12-150-1W121503.31(3)53BFM12-200-1W122004.41(3)54BFM12-300-1W123006.61(3)55BFM12-334-1W123347.41(3)用途高电压并联电容器主要应用于50Hz或60Hz交流电力系统以改善功率因数。产品性能符合GB3983.2-89《高电压并联电容器》及国际标准IEC60871-1。使用条件1、海拔高度不超过1000m，环境空气温度-40℃~+40℃。2、安装场所无剧烈的机械振动、无有害气体及蒸汽、无导电性及 爆炸性尘埃。3、连续运行电压1.0Un，长期过电压最高值不超过1.1Un。4、稳态过电流(包括谐波电流)不超过1.43In。5、最大允许容量不超过1.35Qn。型号说明*液体介质代号               F-浸渍剂为二芳基乙烷W-浸渍剂为烷基苯            A-浸渍剂为苄基甲苯** 固体介质代号             F-聚丙烯薄膜和电容器纸复合介质                              M-全薄膜介质主要规格